Cook H-Series Manual do Utilizador descarregar pdf

Hooded Propeller Roof Fans

INSTALLATION, OPERATION, AND MAINTENANCE MANUAL

H-Series

This publication contains the installation, operation and

maintenance instructions for standard units of the H-Series

Hooded Propeller Roof Fans.

•HEE/HES •HXF

•HEF •HEE-D/HES-D

•HER •HEF-D

•HXE/HXS •HER-D

Carefully read this publication and any

supplemental documents prior to any

installation or maintenance procedure.

Loren Cook catalogs H-Series Belt Drive and H-Series

Direct Drive provide additional information describing the

equipment, fan performance, available accessories and

specification data.

For additional safety information, refer to AMCA

publication 410-96, Safety Practices for Users and

Installers of Industrial and Commercial Fans.

All of the publications listed above can be obtained from

Loren Cook Company by phoning (417)869-6474,

extension 166; by FAX at (417)832-9431; or by e-mail at

[email protected].

For information on special equipment, contact Loren

Cook Company Customer Service Department at

(417)869-6474.

Receiving and Inspection

Carefully inspect the fan and accessories for any

damage and shortage immediately upon receipt of the fan.

• Turn the propeller by hand to ensure it turns freely and

does not bind.

• Check dampers (if included) for free operation of all

moving parts.

• Record on the Delivery Receipt any visible sign of

damage.

Rotating Parts & Electrical Shock Hazard:

Disconnect electric power before working on unit.

Follow proper lockout / tagout procedures to ensure

the unit cannot be energized while being installed or

serviced.

A disconnect switch should be placed near the fan in

order that the power can be swiftly cut off, in case of

an emergency and in order that maintenance

personnel are provided complete control of the power

source.

Grounding is required. All field-installed wiring must

be completed by qualified personnel. All field-

installed wiring must comply with National Electric

Code (NFPA 70) and all applicable local codes.

Failure to follow these instructions could result in

death or serious injury.

H-Series

Handling

Lift the fan by the base or by the shipping carton.

NOTICE! Never lift by the shaft, motor or housing.

NOTICE! If your fan has a special protective finish,

handle with extreme care. Even a small chip will break the

coating’s continuity and destroy its ability to protect the

metal.

Propellers are carefully balanced to give smooth,

vibration-free operation. If the propeller is damaged during

handling, it will require rebalancing.

Storage

If the fan is stored for any length of time prior to

installation, store it in its original shipping crate and protect

it from dust, debris and the weather.

Outdoor Storage

To maintain good working condition of the fan when it is

stored outdoors or at a construction site, follow the

instructions below.

• Coat the shaft and bearings with grease or rust

preventative compound to help seal out moisture.

• Periodically rotate the propeller and operate the

dampers (if supplied) to keep a coating of grease on all

internal bearing parts.

• Periodically inspect the fan to prevent damaging

conditions.

• Block propeller to prevent natural rotation.

• Cover the unit with some type of weather cover to

prevent moisture, corrosion, dirt or dust accumulation.

1 2 3 4 5 6 7 8

Resumo do Conteúdo

Página 1 - H-Series

Hooded Propeller Roof FansINSTALLATION, OPERATION, AND MAINTENANCE MANUALH-SeriesThis publication contains the installation, operation and maintenance

Página 2 - Installation

2456172839L1L2L3456789123L1L2L3Low Voltage208/230 VoltsHigh Voltage460 Volts3 Phase, 9 Lead MotorY-ConnectionFanMotorDamperMotor*SecondDamperMotorTran

Página 3 - Figure 4

3The motor should be mounted in order that the motor plate is between the fan shaft and the motor shaft.a. Remove the motor plate mounting bolts and t

Página 4 - Operation

4c. Install the two perimeter angles (C), that were shipped loose, inside each end of the hood.d. If there is a gap between the top cap edges, loosen

Página 5 - Fan Bearings

5In the event that the bearing cannot be seen, use no more than three injections with a hand operated grease gun.Motor BearingsMotors are provided wit

Página 6 - Maximum RPM

6Changing Shaft SpeedAll belt driven H-Series fans with motors up to and includ-ing 5HP are equipped with variable pitch pulleys. To change the fan sp

Página 7 - HEE-D/HES-D/HER-D Parts List

7TroubleshootingProblem and Potential CauseLow Capacity or Pressure•Incorrect direction of rotation. Make sure the fan rotates in same direction as th

Página 8 - HEF-D Parts List

8765432110119812131516 14Corporate Offices: 2015 E. Dale Street Springfield, MO 65803 417.869.6474lorencook.comH-Series IOM - Jan 20142120191817161

Comentários a estes Manuais

Sem comentários

Cook H-Series Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Cozinha Cook H-Series. COOK H-Series User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Cozinha Cook H-Series